Introduction：

A pen holder designed for tools commonly used by hardware engineers, such as screwdrivers and tweezers. More convenient and clear at a glance.

------------------------------------------------------------------------------------------------------------------------------

advantages：

-Can be hung on the partition wall of a general workstation

-You can find the screwdriver with the corresponding bit at a glance.

-Tweezers are easier to access.

------------------------------------------------------------------------------------------------------------------------------

Printing suggestions：

The default printing direction allows you to color the bottom of the inner wall for a better look. However, it will lead to poor printing quality of the side fence and low strength in the XY direction. I myself broke the entire side fence while removing the supports（ orz…）.

However, the side fence does not affect the use, as shown in my photos.

I recommend rotating it 90 degrees and printing sideways. Print with only one color of material.

This way, less support is needed, This way, fewer supports are needed, printing is faster and stronger.