7" tall Cactus Lamp design.
I made this as a commission, but thought it was too cool not to share. I designed the lamp for a lamp kit I purchased at Lowe's (details below). for my print, I used glow-in-the-dark filament for the needles and Light green for the cactus body (please note, you have to use a light green or the light will not pass through). All print settings used are saved in the files, but I mainly used the standard settings except a support angle at 45 degrees. the support material in the cactus body is a little difficult, but with a pair of needle nose plyers, you can work it out pretty easily. The needles print with a small brim and I melted them onto the cactus.
Lamp Kit information:
Project Source 60-Watt Plastic Turn Knob Lamp Socket, Clear
LOWES Part #745328