A simple cover for the outside of the poop chute to hold heat in the printer when a high chamber temperature is needed e.g. ASA, ABS, PC, PA. I managed to get another 5-8 degrees of temp just using this mod.

Uses four 6x3 magnets to attach itself to the printer. There is a small raised lip which helps to locate the shield in place. The model also features a debossed section on the sides to aid in removal when not needed. A small Bambu logo on the ends just for flair.

This is designed ONLY to be used when needing a high chamber temperature and NOT recommended for AMS or normal printing as the chute will back up very quickly.

I recommend printing in PETG rather than PLA as the temps can get close to the glass transition point of PLA.

DISCLAIMER: Use at your own discretion. I'm not liable for misuse of this tool and any consequences that may arise from using it. This mod is helpful for me and suits the processes I use but may not suit everyone's application.