May the odds be ever in your favor……
Artwork of the Mockingjay from The Hunger Games optimized and hueforged for filament painting!
I really like how the the flames turned out on this one.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
Generic Black, Red, Orange, Yellow, White PLA+ filaments
Swap Instructions:
Start with Black
At layer #3 (0.32mm) swap to Red
At layer #11 (0.96mm) swap to Orange
At layer #19 (1.6mm) swap to Yellow
At layer #27 (2.24mm) swap to White for the rest.
For makers with a single AMS unit. Print order is as follows:
Slot 1: Black → Slot 2: Red → Slot 3: Orange → Slot 4: Yellow → Pause → Slot 1: White
You will need to swap out the roll of Black filament in Slot 1 for White. This can be done anytime between layers 3 and 26. I've added a pause on layer 26 in the print profile to help with this. Feel free to remove it when slicing if not needed.
For makers without an AMS unit
Please use the profile labelled NO AMS. In this profile, the color changes have been replaced with pauses where you should manually change filaments (refer to swap instructions).
Need a frame for this? Check out my Low Profile Frame for 20 x 20 Hueforge Prints!
Post your makes and have fun!
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.