Here is the cover of the movie “Avatar”, have fun with it!
If you are missing a shelf to put the picture or the other Hueforge pictures on the wall, take a look at my HueShelf ;)
Instructions:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Generic Black Transmission Distance: 0.3
PLA Generic Blue Transmission Distance: 2.5
PLA Generic Teal Transmission Distance: 0.5
PLA Generic Yellow Transmission Distance: 6
PLA Generic White Transmission Distance: 6
Swap Instructions:
Start with Black
At layer #3 (0.32mm) swap to Blue
At layer #9 (0.8mm) swap to Polymaker Teal
At layer #12 (1.04mm) swap to Yellow
At layer #14 (1.2mm) swap to White
Enjoy and Share your results!