V-Spooler Drill Attachment
Copyright Claim
V-Spooler Drill Attachment
Boost
19
48
13
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
27 min
1 plate
Boost
19
48
13
0
140
88
Released
Description
I printed out the V-Spooler by Fryby Additive and by default it prints out the hand crank version. Well after hand cranking for a bit I wanted to switch to drill power. To switch I would have to dissamble the spooler to put a different shaft in which I didn't want to do. So I created this adapter that utilizes the hand crank spindle but allows you to plug in a power drill instead of hand crank.
The V-Spooler is available here → https://makerworld.com/en/models/98832
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 100% infill
works well!!! thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
Fast print. Did mine in PETG, has a great fit for both my drill and V Spooler
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
printed just fine - not the same story for the brass inserts...
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
all good
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
good print. added a motor so can't use this now.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
actually worked really well and I didn't have to completely disassemble the spooler. already responded 3 spools with this and holding up great
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld