A new version of the great Oosh Proto Spool Holder design

I've included only the standard BambuLab holder with the 59mm width and removed the width labels and the arrows that were sculpted on the original model. 

I've also completely redone the supports that were a little hard to remove on the original design. 

Last but not least, the print time has been reduced to 2h 2min from 3h 49min of the original one.

This design uses 4x 19x10x5 standard bearings for better spool rotation. 

Oosh Proto on the original design link has a .pdf that shows how to assemble the spool holder.

Please visit Oosh Proto profile for some awesome designs, including an incredible MMS manual material system using this spoolholder!

All credits for this design should go to him!