Silica Gel Drying Box for Eibos Cyclopes
Copyright Claim
Silica Gel Drying Box for Eibos Cyclopes
Boost
6
9
5
Print Profile(2)
Bigger Box 0.28mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
Smaller Box 0.28mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Boost
6
9
5
0
14
18
Released
Description
2 Sizes of the box for drying silica gel in Eibos Cyclopes.
Recommended to print with PETG to avoid deflections.
After drying it can be used for holding silica gel in a box with filaments.
I highly recommend making a riser for bearing as well.
This will avoid overheating
https://makerworld.com/en/models/89195
Checkout my profile for more models: https://makerworld.com/en/@AngryPearl
Comment & Rating (5)
All
Print Profile
Bigger Box 0.28mm layer, 2 walls, 15% infill
Great model. I'm going to have to do another it if ASA soon. PETG is warping a good bit on the bottom in the dryer
The designer has replied
1
Reply
Thanks for rating. You can try my riser, and with it, I don't have a problem with warping even with PETG
https://makerworld.com/en/models/89195#profileId-95485
0
Reply
Print Profile
Bigger Box 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Smaller Box 0.28mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for rating. I would recommend also trying a riser for the bearing, to prevent overheating this print.
https://makerworld.com/en/models/89195
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld