UPDATE: garm96101 commented to try double sided foam tape to help reduce the torque that the handle can be subjected to if you pull in the wrong way. Place a single piece at the top and bottom of the handle to stick it to the glass. I had a chance to try it out and it was an excellent suggestion! Please consider that as part of the original design and installation now. Thanks garm96101!

I wasn't a fan of the stock handle pinch/pull design, and most models posted here used the same idea slightly modified. In my experience it wasn't very ergonomic and was impossible to use it without smudging the glass. This design was inspired by the common designs seen in home appliances. Must be decent enough if most appliance companies are using it. I've been using this for several months and super happy with it.

Any standard print settings/material should work fine, this was printed with the stock 0.2mm layer Bambu Studio print profile with Sunlu PLA. Designed to be printed laying on its side. Just re-use the stock handle mounting screws and grommets, threaded directly into the plastic. As with all of the handle mods, BE CAREFUL NOT TO OVERTIGHTEN THE MOUNTING SCREWS! Fusion 360 source & .STEP files included.