Rubber Band Gun
Copyright Claim
Rubber Band Gun
Boost
25
37
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
2 plates
Boost
25
37
7
0
161
99
Released
Description
Rubber band gun , can load up to 7 shots.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
came out well, screws weren’t correct size to fit in holes though
(Edited)
The designer has replied
0
Reply
is it too big or too small? it’s for positioning, I was trying to make it as tight as possible so no glue is needed.
0
Reply
Replying to @johnstylez
They were barely too big so shouldn’t need much adjusting
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Los pernos o clavos no calzaban asi que tuve que pegarlos con kolaloka, pero fuera de eso excelente diseño
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fdasfsadfa
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld