Have you had a bad day at work? Not sure which F word phrase to use for the latest situation? Let the wheel decide your response. Spoiler.. all of them are F#$!.

This was made as a gift and the only picture taken was of an earlier version with three windows cutout for the swear words, hence the difference between the file and photo. The final file has only one window since the goal is to spin and let it pick a phrase for you. I have also added a hook/handle to the bottom half. This allows it to be hung on a wall to literally facilitate the banging of your head, or just making it easier to hold onto while spinning.

Each object will print on a plate separately but nothing special needs to be done except filament changes. Ironing all top layers is also optional for a smoother finish. The bottom takes about an hour and the top is about 2.

• For the bottom half- start with white until the F words are complete, then black to make the white stand out and end with red for the middle core (to match the bullseye top). Printing at a 0.2mm layer height would mean a filament change at layer 9 and 21 for this. You could always switch the black and white, as long as there is a contrasting colour to show the lettering.
• For the top bullseye- start with white until the inner, lower level rings are complete and then end with the red rings. At a 0.2mm height this means a filament change at layer 25.

Assembly: Snap the bottom and top together (it takes a bit of force but it will go!) and then spin away that rage.