Blink Camera Door mount P1S, X1C - offset 22.5 degrees angle
Remixed by
Copyright Claim
Blink Camera Door mount P1S, X1C - offset 22.5 degrees angle
Remixed by
Boost
7
20
11
Print Profile(2)
0.16mm layer, 3 walls, 15% infill
Designer
28 min
1 plate
0.28mm layer, 1 walls, 15% infill
24 min
1 plate
Boost
7
20
11
0
42
41
Released
Description
Mount fo Blink Camera mounted on the door of the P1S or X1C.
This is a remix with some upgrades.
Offset the mount from the door hinge to allow the door to open fully without bumping the camera
Camera mount given a 22.5 degree of down angle to give the chamber more visibility.
Incresed strenth with 3 wall loops.
Bambu PLA Basic
0.16mm Optimal @BBL X1C
Comment & Rating (11)
All
Print Profile
0.16mm layer, 3 walls, 15% infill
very good
0
Reply
ive needed a side loader for my units are close to the wall. this is fantastic.. i cant wait to print this
1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
It print out fine but I decided to go a different direction for my camera mounting.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
gooddddd
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Works as intended, Slightly undersized but a dab of glue and holds perfect and at a Great angle!
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Camera fell off I had to glue it on
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Printed nicely but did not fit snugly in the socket of my camera. Will try some tweaks to the settings and print again
0
Reply
What size screws did you use? The factory screws are to small. Thanks
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
This remix is based on
The model does not exist anymoreLicense
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld