Chinese Dragon Head Incense Holder
Chinese Dragon Head Incense Holder
Boost
149
181
23
Print Profile(4)
Ashtray_FineModel_withSupport
Designer
1.9 h
1 plate
HeadOnly_Fine_withSupport
Designer
1.4 h
1 plate
0.12mm layer, 2 walls, 15% infill Tree Supports
2.4 h
1 plate
Complete or Only Head Plates - 0.12mm layer, 2 walls, 15% infill
4.1 h
2 plates
Boost
149
181
23
0
332
212
Released
Description
This is incense holder that you put the incense stick into Chinese dragon mount. There are two option; one with ashtray, one with just head.
The dragon head I used from this model.
Comment & Rating (23)
All
Print Profile
Ashtray_FineModel_withSupport
0
Reply
Print Profile
Ashtray_FineModel_withSupport
0
Reply
Print Profile
Ashtray_FineModel_withSupport
The ashtray is too short for normal incense sticks so that the ash does not fall into the bowl.
The designer has replied
0
Reply
sorry to hear that. It worked for me btw. you may try to trim the incence rod. I’ll update my design for sure.
0
Reply
Print Profile
Ashtray_FineModel_withSupport
very good design . But lost one horn in print but created a spare and looks ok . does the job ok though
0
Reply
Print Profile
Ashtray_FineModel_withSupport
Super Modell. Ich habe es mit PLA Silk in weiß gedruckt.
0
Reply
Print Profile
Ashtray_FineModel_withSupport
perfectly with x1c
0
Reply
Feels a bit risky with glowing embers on a PLA bed
0
Reply
非常喜欢，很好的设计
0
Reply
Print Profile
Ashtray_FineModel_withSupport
0
Reply
Print Profile
Ashtray_FineModel_withSupport
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld