Harry Potter coaster collection
Boost
81
183
16
Print Profile(1)
0.16mm layer, 2 walls, 35% infill
Designer
1.4 h
1 plate
Boost
81
183
16
0
234
82
Released
Description
I have prepared a collection of coasters from the world of Harry Potter for you. The collection consists of six coasters and one stand. The diameter of the coasters is 100mm and the height is 4mm. I recommend printing the stand with a collar and supports, without them spaghetti will start to do it. I hope you will like it and I wish you trouble-free printing
For a nicer look of the coaster, I recommend printing with the picture to the pad
Coasters printed on a layer of 0.16 with a 35% fill
Stand printed on layer 0.12 with 35% fill + support
The whole collection of coasters can be found in Raw Model Files thanks.
Have a nice rest of the day
Comment & Rating (16)
All
beutiful
The designer has replied
0
Reply
Thanks
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
it didn't need a brim and I was shocked it wasn't the whole collection available to print as shown in main picture
The designer has replied
0
Reply
The entire collection shown in the picture is in the Raw Model Files tab, just take a look. I have the edge there just to be sure, because a few coasters have already lifted off the mat.
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Good print, used generic black and grey pla, not sure if the brim is really required.
The designer has replied
0
Reply
I'm not sure if it's necessary for everyone, but the coaster started to rise from one side when I was printing. That's why I already set the brim on each coaster. I always quickly deburr it with a knife. Thanks for printing and commenting
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Awesome!! Love it, printed upside down, 2 Colors on my brand new p1s! seems to only have 1 model, could not find other plates. thanks!!
(Edited)
0
Reply
Only one plate with one coaster
The designer has replied
0
Reply
the others are in raw model files, it is written in the label
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
very nice. I printed them upside down to improve the pictures surface
The designer has replied
0
Reply
thank you for the positive rating and I'm glad you like the model
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld