AMS Adapter for Elegoo Cardboard Spool
Copyright Claim
AMS Adapter for Elegoo Cardboard Spool
Boost
39
97
22
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
33 min
1 plate
Boost
39
97
22
0
125
154
Released
Description
Elegoo PLA is very affordable with very good quality and a smooth, nice finish.
Printable with up to 22 mm³/sec on 0.4 nozzle.
The inner cardboard core of the Elegoo spool matches perfectly the AMS Masterspool, only the winding core is 2.4mm smaller.
You only need to make two cuts with a side cutter so that the locking lug can sink flush into the cardboard sleeve.
Have fun printing!
Comment & Rating (22)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
printed out great
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Printed well, depends of the filament you may need or not but is better to have just in case.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
fits really well :)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
works as described
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Very economical! I love fast and cheap prints like this. Spool rims wear out too fast, and I prefer to adapt something to fit the BambuLab reusable spool whenever possible. Thanks!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
worked great makes cardboard spools almost the same as bambu refills
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Perfect!
(eu stock from Amazon) Elegoo PLA 1kg
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Makes it so much easier to use elegoo spools. No need to wind it over to bambu spools!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld