BambuLab AMS Latch Cover
Copyright Claim
BambuLab AMS Latch Cover
Boost
4
8
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
23 min
1 plate
Boost
4
8
3
0
12
7
Released
Description
I designed these because most of my filament rolls are just a little too tall for the AMS. The pictured covers were printed with my X1 Carbon, and they fit perfectly with a slight press fit.
V2: I've found that a few spools are even a little too big for the original cover, now that I added the Hydra mod, so I made one a bit taller.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
passt sehr gut , und das AMS lässt sich viel leichter öffnen
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld