Bambu Lab Poop Control Chute Guide/Shroud

This is a guide that fits onto the back of the "X1 & "P1" series of printers and helps contain and control the poop/purged filament.

This is very useful if you have your printer on a table and want to catch the poop/purged filament in a containcer under the table below the printer. Without this it can sometimes be difficult to catch it as it will often be ejected from the printer at an inconsistent angle/speed.

It features an open top design to allow you to be able to look in and see if there are any blockages and if there are, you can reach in with your hand or use something appropriate to poke it down.

It is very easily installed to the back of the printer using some 10mm wide double sided tape on either side. “3M” branded is a good option to ensure it will not easily fall off. It will hold in place very well however can be easily removed if you need to without leaving any sticky reside and no need to drill holes.

Filament In pictures: “AzureFilm” Anthracite Grey