Scribing tool
Copyright Claim
Scribing tool
Boost
7
21
8
Print Profile(2)
PLA - 0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
PETG - 0.2mm layer, 4 walls, 15% infill
Designer
1 h
1 plate
Boost
7
21
8
0
33
32
Released
Description
This is a scribing tool. You can place a pencil through the hole and then scribe at 1/8" increments between 1/4 -1 inches. Great for carpentry, cabinet installing, construction, and general woodworking. I have included two print profiles: PLA and PETG. I measured a bunch of different pencils I had laying around and chose a hole size that worked the best. It's a nice snug fit for my pencils, but since not all pencils are the same, you may need to try different ones or reem out the hole if necessary.
I did not come up with this design. I have seen similar products for sale on Temu and Amazon I believe.
Comment & Rating (8)
All
Print Profile
PLA - 0.2mm layer, 4 walls, 15% infill
nice clean print can't wait to try it out
The designer has replied
0
Reply
let me know how it works for you!
0
Reply
printed great. I added a couple of small o rings to the pencil to help keep it from slipping as your are scribing the wood
0
Reply
can you also do it in mm?
The designer has replied
0
Reply
yes! look at my profile, I have a metric version as well
0
Reply
Replying to @dfreshkremer
thanks! i give it a 5* rate :) when i print it
0
Reply
Print Profile
PLA - 0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
PLA - 0.2mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld