Xbox Series S Feet / Risers
Remixed by
Copyright Claim
Xbox Series S Feet / Risers
Remixed by
Boost
8
11
9
Print Profile(2)
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
Designer
1.5 h
1 plate
0.2mm layer, 2 walls, 20% infill
Designer
1.2 h
1 plate
Boost
8
11
9
0
30
27
Released
Description
Feet to put on your Xbox Series S to raise it up and help improve ventilation by distancing it a little more from the table its sitting on. Will need four, one for each corner as set up in the profile.
v2 Stylin' Profile: Added smaller holes similar to the styling of case on the Xbox for those looking for something more aesthetically matching. Added a reference picture so you can see which profile is which version.
Comment & Rating (9)
All
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
Keeping things Cool.! Much better air flow.
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
(Edited)
0
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
printed perfectly, no supports, no blemishesz works great
1
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
(Edited)
1
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
v2 Stylin' 0.2mm layer, 2 walls, 20% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld