Bambulab Multi Filament Spool for A1 MINI - 2 Filaments
Remixed by
Copyright Claim
Bambulab Multi Filament Spool for A1 MINI - 2 Filaments
Remixed by
Boost
36
61
9
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.8 h
3 plates
Boost
36
61
9
0
85
84
Released
Description
Bambu Lab Multi Filament Spool for A1 MINI ONLY
Introduction
A multi-filament drop-in replacement for the bambulab spool. This model is an adaptation for the A1 Mini Buildplate.
You'll be able to insert up to 2 different filament in a single spool. Useful if you have samples or leftover on many spools.
It is also available a 4 Filament Spool Version here
What you'll need:
Filament Clip
To stop the filament from unwinding you'll need this filament clip:
Assembly instructions
- twist the bambulab spool to open it in half
- align every spool disk as shown in the illustration, taking care to align the internal channels
- insert the dovetail stoppers (the 2 trapezoid pieces) inside the channels
- put together the bambulab spool and twist it back in position the 2 halves
Filament insertion
- Straighten up the end of the filament
- Fold at 90 degree angle the last 2-3 mm using a plier.
- Put the curved filament in the hole
- Start winding it mantaining tension on the spool for the first couple of turns
Comment & Rating (9)
All
Excellent for the A1, printed from the app... 🔝
The designer has replied
1
Reply
Thank you for sharing your result! Enjoy
0
Reply
what’s the difference to the not A1 version ?
The designer has replied
0
Reply
It's smaller so it fits on the a1 mini buildplate
(Edited)2
Reply
only if it worked
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
worked perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
(Edited)
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld