Ikea Kallax - Lego Stand Case
Boost
90
173
5
Print Profile(2)
0.28mm layer, 2 walls, 10% infill
Designer
23.4 h
6 plates
BBL PLA - 0.28mm layer, 2 walls, 10% infill
Designer
17.1 h
6 plates
Boost
90
173
5
0
113
18
Released
Description
I did these quick inserts specifically for Ikea Kallax.
*Use double sided tape to make them more stable as you like.
* I printed with Sunlu PETG. You can print with PLA to further reduce the print time.
Please check the size of your toys, figures, or legos, some might not fit in the height or width.
Part B and C (3x) are meant to be printed together to fit in Kallax inner width.
Hope this design will help you get some cool setup for your Kallax!
Comment & Rating (5)
All
Looks cool! is it possible to have a picture of your set up (desk)/room please? because I also have the same ikea desk and kallax and It looks like you have a similar place like mine. Thanks in advance!
The designer has replied
1
Reply
Thanks for kind comment! my current desk setup is still a mess since i'm working with 3 monitors ( 2 4k and a large Wacom). Right now it looks like this
(Edited)
0
Reply
Replying to @vince27495
it's really cool!!! thanks for sharing
0
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
These are a perfect fit for my Kalax and will allow a nice way to show off my 3D prints but also store stuff behind them.
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld