Small AMS Desiccant Funnel
Copyright Claim
Small AMS Desiccant Funnel
Boost
8
28
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Boost
8
28
9
0
76
35
Released
Description
I printed the small dessicant holder for the AMS - it fits into the corners. To easily pour the beads in was tough. Originally, I used paper. Now - I made a model to make it easier!
The ridge on the print prevents it from sliding into the holder too far. Bonus - you can use it to pour the beads out as well!
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
would be nice to know which desiccant holder this fits or the dimensions of the outlet side of the funnel
The designer has replied
0
Reply
It is for the small desiccant holder for the AMS - in the title. Once you load the file - the dimensions can be seen in the slicer.
0
Reply
The corners arent rounded in the one i printed, so it doesnt fit. In the pics it does appear your corners are rounded.
The designer has replied
0
Reply
Good Day,
There is a fillet on the edges. Not sure what print settings you are using. Might need to calibrate the flow and speed too on the filament. I added the fillet because I was worried of a sharp corner not sliding in as easy and the holder has a rounded edge too. Let me know - I will investigate the model as well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld