Everyone's favourite Space Station, now hueforged and ready to be displayed wherever you like!
Another simple print-in-place model without supports needed, though it does take about 5 hours to print due to the details of the ‘Space’ portion of the print. I used 5 colours for this print, but you can get away with 4, by repeating the second colour - blue-grey (you can use grey) for the Death Star.
If you are using the one-click printing on Makerworld, all settings will have been applied to the print. If you are not, or if you want to customise some of the settings yourself, please use the instructions/recommendations below:
Print Instructions:
Filaments Used:
- PLA Flashforge Burnt Titanium Transmission Distance: 6.8
- PLA BambuLab Basic Blue Gray Transmission Distance: 3 (You can use grey here!)
- PLA Sunlu Lilac Transmission Distance: 6.6
- PLA Kingroon White Transmission Distance: 8
- PLA Overture Light Grey (for the Death Star, and you can repeat above grey if you want)
Swap Instructions:
- Start with Burnt Titanium
- At layer #15 (0.76mm) swap to Blue Gray
- At layer #20 (0.96mm) swap to Lilac
- At layer #31 (1.4mm) swap to White for the rest.
- At layer #45 (1.96mm) swap to Light Grey (the Death Star!)
The model for the Death Star should be linked in this page (if I did it correctly!). It's a brilliant model, and if you have the time to spare, absolutely print a full sized version of it for yourself!
____________________________________
Commercial License to Sell Prints
If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!
____________________________________