Sword with Collapsing Blade
Copyright Claim
Sword with Collapsing Blade
Boost
27
32
20
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Boost
27
32
20
0
109
144
Released
Description
This is part of my old sword collection prints when I was into designing swords that could be printed on any printer. This collapsible sword is made to be printed as one part and not requiring you to re-calibrate your printer. I tried printing some other collapsible blades and even with my old printer tuned I still had issues with it. Obviously not an issue now on my Bambu P1S :-)
Comment & Rating (20)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
would not slide out.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
top two parts flew off after printing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
2 last one's where not good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Doesn't work lol don't use ludicrous mode for it
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints well but thin tip is fragile and will jam inside sleeve and break if you push the sword back closed without watching out.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:tip easily broke
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld