Swing lid for trash can - fits on A1 Mini
Copyright Claim
Swing lid for trash can - fits on A1 Mini
Boost
156
307
40
Print Profile(2)
0.2mm layer, 2 walls, 13% infill
Designer
4.4 h
1 plate
A1 Mini: 0.2mm layer, 2 walls, 13% infill
Designer
5.5 h
1 plate
Boost
156
307
40
2
610
185
Released
Description
This lid is designed to fit my trash bin which is designed to fit the A1 Mini bed. See here on MakerWorld.
This model is designed to fit onto the build plate of the Bambu A1 Mini.
Easy to print in any material, but PLA will be sufficient.
Photos show it in Bambu Labs PLA basic black filament.
Size on the print plate is 179W x 179D x 180H (mm).
Please also see my other bin models on my homepage.
Comment & Rating (40)
All
Boosted
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
Fits perfectly!!!! Very happy with the end result. Thankyou.
The designer has replied
0
Reply
That looks really well printed! Thanks for the photo.
0
Reply
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
works great.
The designer has replied
0
Reply
Looks great, too!
0
Reply
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
the dowels don’t stay upright, need a brim etc
difficult to remove supports from the dowel holes
(Edited)
The designer has replied
0
Reply
Thank you, @Jamal, for bringing this to my attention.
For some reason, I had missed these two things on the A1 Mini profile. I have fixed them, double-checked them, and uploaded the corrected profile.
Please accept my apologies for the mistake.
(Edited)1
Reply
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
little bit unbalanced so it doesn't sit equally when not in use so I stuck a bit of bluetack on the underside of the lid to balance it out. Very minor gripe, otherwise fantastic print!!
The designer has replied
0
Reply
@carlbrinsden Sorry to hear that it didn't sit straight. The only reason that I could think that it would do this is that maybe the infill was slightly to one side. Or maybe it was the seams. In any event, your little hack to fix it is brilliant.
Thanks for the 5 stars and the feedback.
0
Reply
awsome design, but i would recommend using adaptive layer height in the slicer for the top of the "Swing lid" part :)
The designer has replied
0
Reply
Thanks for the comment and suggestion. I did consider it but didn’t want to take the risk that the outside of the part might look a bit inconsistent. I will run a test print off with your suggestion and see if the result looks fine.
Glad that you liked the design.
0
Reply
Nice
0
Reply
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
prints well. the holes that the dowels connect into needed re-enforcing post-print, so they could be made stronger.
0
Reply
Print Profile
A1 Mini: 0.2mm layer, 2 walls, 13% infill
Have a little problem coused by my filament. Design and profile is perfect.
0
Reply
Print Profile
0.2mm layer, 2 walls, 13% infill
top
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 13% infill
worked perfectly first time! great job.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld