⛄ Iceberg stash box
Copyright Claim
⛄ Iceberg stash box
Boost
68
92
25
Print Profile(2)
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
54 min
1 plate
Full Size, 0.2mm layer, 3 walls, 5% infill
2.7 h
1 plate
Boost
68
92
25
0
156
120
Released
Description
screw top, sharp!!
UPDATED 11/23 with new lid that is easier to line-up without drawing blood.
Comment & Rating (25)
All
Print Profile
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
Nice model, but I couldnt screw it on all the way without (coming close) to drawing blood.
The designer has replied
0
Reply
IT'S SO SHARP. Yeah I had the same issue. It's cool but a bit too defensive.
(Edited)1
Reply
Replying to @moonrakerone
I added a new lid with a little rotation that will hopefully line up easier.
0
Reply
Replying to @TripleGWorkshop
I have swapped in v2's lid to my profile, thanks for the update!
(Edited)1
Reply
Print Profile
Full Size, 0.2mm layer, 3 walls, 5% infill
printed ok, some stringing, treads are bad, takes a while to sand them down so they actually go into each other (to designer/maker, you should extrude cut the treads to a slightly smaller size on male side and open up the female side a little bit)
this is as far as I can tread the parts (in picture)
(Edited)
0
Reply
Print Profile
Full Size, 0.2mm layer, 3 walls, 5% infill
Pretty nice, came out beautiful.
1
Reply
problem with the 3MF file, the scaled is null
(Edited)The designer has replied
0
Reply
not sure what you mean. The 3mf file is from prusaslicer so you may have to get the STL's
0
Reply
Print Profile
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
Did not close very well
0
Reply
Print Profile
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
printed with petg translucent filament
needs some sanding work will fit into the thread.
(Edited)0
Reply
Print Profile
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
Printed good but supports were hard to remove.
0
Reply
Print Profile
50% Scaled, supports, 0.2mm layer, 2 walls, 15% infill
Difficulty printing the top without supports, and when printed with supports, the supports were hard to take off.
0
Reply
I added a new lid with a little rotation that will hopefully line up easier.
0
Reply
Print Profile
Full Size, 0.2mm layer, 3 walls, 5% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld