I wanted to calibrate both inside and outside size at same time, I have also added a small radius to top of block bore to prevent top layer from causing hole to read smaller.
Calibrate Layers, Temp, Speed, Exterior & Inside Size.
Print Model
Nominal outside is 1"x1"x1" (Adjust X-Y Compensation)
Nominal inside is .750" (Adjust X-Y Contour Compensation)
****.05mm will change size approx .002"
I used smooth plate
3 Top/Bottom layers
2 walls
15% infill
.2 layer height
This is my first time uploading on any site, here or… the other, if this gains some likes I will add many more models I have created over the years.
Thank You!