A1/A1 mini Ams-Lite stand ( print In one piece )
Remixed by
Copyright Claim
A1/A1 mini Ams-Lite stand ( print In one piece )
Remixed by
Boost
147
274
57
Print Profile(3)
0.2mm layer, 3 walls, 15% infill
Designer
58 min
1 plate
0.24mm layer, 3 walls, 20% infill
Designer
9.8 h
1 plate
0.24mm layer, 3 walls, 20% infill
Designer
1.6 h
1 plate
Boost
147
274
57
0
478
249
Released
Description
I decided to make some changes to this great design. I have assembled it so that you can print it in one piece so that you don't have to assemble more than absolutely necessary. It's solid, doesn't move during printing, it doesn't tip over easily either.. Then I've also added a holder in the cover for the filament Pliers.
In addition the side of the screws from the AMSlite body of the corresponding holes screws, so only need to be put into the base before the screws down, put on the base and then screwed up with the base on the OK.
Comment & Rating (57)
All
Print Profile
0.24mm layer, 3 walls, 20% infill
Printed with basic PLA, works perfectly, uses up about 1/2 the desk space. Thanks!
0
Reply
Replying to @Hostettler.mike
I DONT UNDERSTAND HOW U GET THE CORD THROUGH?
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
thanks for design, its perfect
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
Nice and easy print
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Sehr gut. Perfekt angepasst und sorgt für die nötige Übersicht.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Came out perfect
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
Great
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
Other Issues:Makerworld will not allow me to rate this 5 star, says I did not print the file....
0
Reply
Print Profile
0.24mm layer, 3 walls, 20% infill
Support Issue:I had to cancel the first attempt with no support because the screw hole was warped. printed fine after adding support for the very bottom.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld