Wyze cam v3 mount for bambu lid
Copyright Claim
Wyze cam v3 mount for bambu lid
Boost
48
130
19
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
0.16mm layer, 2 walls, 5% infill
1 h
1 plate
Boost
48
130
19
1
125
96
Released
Description
Top glass camera mount for wyze cam V3, replaces stock handle. I used 10mm X 3.5mm rubber door bumbers on the bottom side to keep vibrations down, insert the spacer on the top side of the glass around the screws to prevent it from pulling the mount on an angle when tightened. Camera is a snug fit but I intended it to be so it doesn't rattle out, it will snap in nice and tight
Comment & Rating (19)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed great, attached easily, fit snug.
Used Sunlu Pla+ in black and Bambu Support filament for the interface.
Thanks!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Scale up to 103% on a V4 perfectly snug
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed clean, worked great until I decided I needed a different top riser, but nothing wrong with the model
The designer has replied
0
Reply
I just added a new riser too and the glass sits on more of an angle, i tweaked the model to work good with it, can upload it if your intersted
(Edited)1
Reply
Replying to @madizmo
yes please if you still have this!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Worked flawlessly
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
smooth as Glass.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Fits v3 perfectly and can fit v4 with a little squeeze. Scale the model up by approximately 5% and it fits v4 almost perfectly.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed great i. pla basic
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
print and finish was perfect it just isn't the angle I wanted for watching layers as well so I went with the door mount instead
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 5% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld