A snug honeycomb stands for the Korg NTS-2 Oscilloscope. The print fits like a dream between the unit's corner screws and rubber feet. The unit sits at a 50-degree angle, the same angle that comes with the unit's clear acrylic stand. The unit sits 20mm above the ground for cable clearance typically found with DAW-less setups. The battery compartment is still accessible with the stand attached to the unit.
Assembly:
Printed supports are not necessary. To attach the stands, the corner screws must be removed to slide the stand onto the unit. The left stand has a cutout for the battery compartment found on the unit.
Notes:
This was printed with the standard 15% infill which results in the stand being easily movable due to its lightweight nature. A possible fix would be increasing the infill percentage but the stand may still be light for aggressive tabletop use.
The same stand structure is available in the Korg NTS-1 and Korg Volca series. This stand is also available with an extended base to accompany an Arturia Keystep.