Sunlu S2 Clip-On Filament Outlet by Zalachenko

Zalachenko

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

14 min

1 plate

4.4(11)

Boost

102

Released

Description

Description:

Design features two main components: the main outlet and the bottom wedge. The main outlet efficiently directs the filament tangentially to the spool, while the bottom wedge ensures a secure and stable hold. Outlet enables you to use it as horizontal or vertical outlet. Assemble effortlessly and upgrade your filament drying process with this practical, tape-free solution.

Installation:

Attach the main outlet to the dryer's exit port. You can use it as horizontal or vertical outlet.
Secure it in place with the bottom wedge for a stable fit. Use pliers as there is little space
Enjoy a reliable and neat filament guiding system.

Print setting recomendations:

PETG, ABS, ASA
0.4 mm nozzle
3 perimeters
4 top and bottom layers
100% infill

Comment & Rating (13)

@dryfiredude

Exactly what I needed. quick and easy print too! thanks

@Killdozer666

Print Profile

0.2mm layer, 2 walls, 15% infill

It works! Printed on P1S with PLA. Installed as instructed, with the addition of hot glue to the underside to make it sturdy. I heat threaded the fitting into the print. Filament: Flashforge PLA Burnt Titanium

@nickeelen

Print Profile

0.2mm layer, 2 walls, 15% infill

@Tega3D

Print Profile

0.2mm layer, 2 walls, 15% infill

@dryfiredude

Print Profile

0.2mm layer, 2 walls, 15% infill

Print quality wasn’t as good as anything else I have printed. The design wobbled a lot, and wasn’t easy to get the filament out of the dryer and into the ptfe. I swapped this out with one that I hot glued in place and allowed PTFE to go all the way into the dryer. I don’t have a picture anymore because it broke when my dryer fell over. That is not a fault of the design or profile though, that was an issue with my dryer setup. had the design been secure and easy to load, I would have reprinted.