This is a bit of a remix of a remix. I made this thing: https://www.thingiverse.com/thing:4690307

Which is a mash up of these two things:
Apple Watch Dock - https://www.thingiverse.com/thing:814577
PG9201 thing - https://www.thingiverse.com/thing:4550426 I used just the "charging pad plain" file.

Pictured are the charges this was designed for.

I got a request for the design file as they wanted to alter it for a Galaxy Note 10+. I made this in Tinkercad so there is no design file to give. So I made this instead. It is sized for a Galaxy Note 10+ and should accommodate it with a case on. It has not been tested! I would suggest printing the test piece to make sure it will fit your phone with it's case before printing the entire thing.

I used the same thing from above for the phone charger as I did in my other thing. This was also raised by 10mm to accommodate the size difference between the Note and the iPhone 12 Pro.

I used this for the watch:
https://www.thingiverse.com/thing:3955615

I have printed this thing for my wife's Galaxy Watch and it fits the watch's charger perfectly.

If something needs altering to make it work better please let me know.

Print it however you think you should. Supports may be needed for the phone charger.