GEMBIRD cardboard spool rim adapter AMS compatible
Copyright Claim
GEMBIRD cardboard spool rim adapter AMS compatible
Boost
5
3
12
Print Profile(1)
0.28mm layer, 1 walls, 0% infill
Designer
9 min
1 plate
Boost
5
3
12
0
20
40
Released
Description
GEMBIRD cardboard spool rim, AMS compatible, Vase mode print. ADVICE: 250° Hotend and turn off all cooling..
Its tight fit but it must be. You must put little effort to put that rim on spool.
Je to fakt na tesno ale jde to nasadit nakonec uplne v pohode, jak nasadite prvni tak uz je to rutina:)….
Doporucuju 250 stupnu na trysce a vypnute chlazeni…
Comment & Rating (12)
All
Works good. You cannot close the lid but there is a print that you can print in order to lift your lid a bit. Good quick print
The designer has replied
0
Reply
I'm confused, so I must have swapped files somehow? Or I don't understand, the gembird spool fits me fine (check pictures). What type of spool do you have exactly?
(Edited)
0
Reply
Print Profile
0.28mm layer, 1 walls, 0% infill
works ok, but should have Been made better
The designer has replied
0
Reply
You're so strict. Not really, should I give the model away so people don't print it? Because you wrote that it works, but you gave it two stars. I don't know when I write a review saying something works and then give it a 2/5 and say it could be done better. It doesn't go together very well.
You know what I'm saying?
0
Reply
unfortunately didn't work well. with fully closed lid, spool will get stuck inside. not enough clearance between lid and spool edges
The designer has replied
0
Reply
are you sure?
(Edited)
0
Reply
Print Profile
0.28mm layer, 1 walls, 0% infill
The designer has replied
0
Reply
🤗
0
Reply
Print Profile
0.28mm layer, 1 walls, 0% infill
The designer has replied
0
Reply
🤗
0
Reply
Print Profile
0.28mm layer, 1 walls, 0% infill
The designer has replied
0
Reply
Thnx;)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld