Gridfinity soldering spool holder in 3 versions:

• Single (max 28mm wide, 60mm diameter | 2x1 Gridfinity)
  • Gridfinity Spool Holder (single)
  • Spool Holder Part 1 (small)
  • Spool Holder Part 2 (small)
• Double (max 60mm wide for both, 65mm diameter | 2x2 Gridfinity)
  • Gridfinity Spool Holder (double)
  • Spool Holder Part 1 (large)
  • Spool Holder Part 2 (large)
• Single wide (max 60mm wide, 65mm diameter | 2x2 Gridfinity)
  • Gridfinity Spool Holder (XXL)
  • Spool Holder Part 1 (large)
  • Spool Holder Part 2 (large)

All have a 2mm guidance hole for the solder wire to pass through.

Can be printed without supports. You do not need any other hardware, the spool holder parts screw together. There should be more than sufficient clearance built into the model for this, if it is still too tight, try an XY hole compensation on Spool Holder Part 2.

Liked this model? Have a look at the rest of my Gridfinity Collection models!