Paladin
Remixed by
Copyright Claim
Paladin
Remixed by
Boost
16
61
12
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
Boost
16
61
12
1
147
108
Released
Description
remix of existing model but with new base that allow for a magnet to be put underneath
| My DnD miniatures | ||
|---|---|---|
|  |  |
 |  |  |
 |  |  |
 |  |  |
 |  |  |
All my models | ||
Comment & Rating (12)
All
Print Profile
0.12mm layer, 2 walls, 15% infill
Your hand-tweaked support settings are fantastic. They just kind of melted off the model.
I'm going to see about using those same settings on some of my other models that give me a hard time.
Thank you!
The designer has replied
0
Reply
@moonrakerone thanks for the compliment ! I have been trying out lots of setting cause some minis are hard to print. glad i can help somebody out with them!
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
one of my favorite models! thanks for sharing your print picture! if you happen to have a Boost token it would help me out if you could boost my model <3
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
One of the best minis i have printed so far!
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Worked great
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld