TP-Link Deco X50 wall mount, design based on TP-Link Deco X50 Design by uahr (Thigiverse).

Problem was that the cables did not have enough room in first attempt design, with placing the screws out of centre this issue is solved.

Also the roundness and fit is improved irl to the mesh router, snug fit.

Holes are made to hold 2 flat or counter sunk 6mm screws.

Print with a little support on the bed only for the LED cut out and the round edge of the mount plate.

Prefer to print in PETG - but works with PLA with at least 15% infill as well.