"Welcome to Jurassic Park - John Hammond"

In this captivating shadow box, a scene from the iconic Jurassic Park movie comes to life. The famous entrance gate looms large, a towering monolith adorned with the park's emblematic name. A car navigates through the colossal gate, its passengers wide-eyed with wonder and trepidation 🦖

I've used the following colors:

• Plate 1: Prusament PLA Gentlemen's Grey
• Plate 2: Prusament PLA Opal Green
• Plate 3:
  - Sunlu PLA+ White
  - at layer #3 - 0.6 mm swap to Fillamentum PLA Extrafill Turquoise Blue
  - at layer #5 - 1 mm swap to Tinmorry PLA Grey
  - at layer #7 - 1.4 mm swap to Sunlu PLA+ Black
  - at layer #9 - 1.8 mm swap to Bambu Lab PLA Green
  - at layer #11 - 2.2 mm swap to Fillamentum PLA Extrafill Signal Red
  - at layer #13 - 2.6 mm swap to Fillamentum PLA Extrafill Orange Orange
• Plate 4:
  - Prusament PLA Galaxy Green
  - at layer #5 - 1 mm swap to Sunlu PAL+ White
  - at layer #7 - 1.4 mm swap to Fillamentum PLA Extrafill Turquoise Blue
• Plate 5:
  - Fillamentum PLA Extrafill Chocolate Brown
  - at layer #4 - 0.8 mm swap to Fillamentum PLA Extrafill Iron Grey
  - at layer #6 - 1.2 mm swap to Sunlu PLA+ Black
  - at layer #8 - 1.6 mm swap to Fillamentum PLA Extrafill Luminous Yellow
  - at layer #10 - 2 mm swap to Fillamentum PLA Extrafill Traffic Red
• Plate 6:
  - PolyMaker PolyTerra Army Dark Green
  - at layer #5 - 1 mm swap to Sunlu PAL+ White
  - at layer #8 - 1.6 mm swap to Fillamentum PLA Extrafill Turquoise Blue
• Plate 7: Fillamentum PLA Extrafill Turquoise Green
• Plate 8: Fillamentum PLA Extrafill Mint
• Plate 9: PolyMaker PolyTerra Peanut
• Plate 10: Sunlu PLA+ White

The colors are just guidelines, you can get creative with the color scheme for a personal touch.

It consists of 10 numbered plates.

You can find the box to display this set here: https://makerworld.com/en/models/13471

The box with lid and the wall mountable box are both Patreon/Printables/Thangs subscriber exclusives. (Box with lid also available for individual purchase on Cults3D)

Print settings

• 0.2 layer height
• No supports
• 100% infill
• Arachne wall generator recommended
• For smooth top finish you could use ironing or print, on a smooth build plate, face down. (not for multicolor)

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Seller Patreon subscription.