Super EZ Camera holder for Blink mini and WYZE OG by HDZ3DWORKS

HDZ3DWORKS

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 100% infill

Designer

6 h

2 plates

4.8(6)

Boost

Released

Description

Here's a simple solution to mounting a Blink Mini camera on your Bambu Lab printer.

I couldn't find a good way to mount my Blink mini cameras on my printer so decided to take a minimalist approach to this problem. Print the box with the angle side down no supports needed and simply slide your camera into the holder and that's it. There's nothing to mount there's nothing to secure it simply sits on the top glass and you don't have to wire anything internally just choose the best spot on the top glass and you're done. This has a 15 degree angle that gives you a great bird's eye view of your printer's build plate.

Printed on my X1C

0.4 nozzle

100% infill

Comment & Rating (15)

@Zeikhyt

Print Profile

0.2mm layer, 2 walls, 100% infill

Excellent but in the end I'm using the upgraded version that attaches to the top lid of the X1C, I forgot about reviewing this

@isonici

Maybe an idea for improvement. Theres a very similar Camera Holder, that mounts to the Glass Plate Opener. Maybe you can adapt that idea.

The designer has replied

@HDZ3DWORKS

isonici Thanks. I’ll definitely check it out. 👍🏼

@user_2457679161

You basically had the same idea for the blink camera. Maybe my version will help you to optimize your design. https://makerworld.com/models/33700#profileId-30699

@HDZ3DWORKS

Replying to @user_2457679161 :

Thanks for the input. I just updated the model and uploaded it. Check it out, thanks for the suggestions I appreciate it.

@Daniel.Ultsch

Print Profile

0.2mm layer, 2 walls, 100% infill

the print works fine but I think it's not the best position for the camera

The designer has replied

@HDZ3DWORKS

Thanks for the feedback. What position could use improvement? Is it the angle of the camera or something else?

@Daniel.Ultsch

yes I think the angle is not very good. the light lowers the video quality and the print head is in the way

(Edited)

@HDZ3DWORKS

Replying to @Daniel.Ultsch :

If you don’t mind try my new model blink mini shorty. The angle is about the same but it sits closer to the top lid handle and locks into place. I left the latch loose on purpose because if it’s too tight it might cause stress on the glass and I don’t want it to break the top glass.