BambuLab AMS Dryer pod with indent for AMS fix
Remixed by
Copyright Claim
BambuLab AMS Dryer pod with indent for AMS fix
Remixed by
Boost
95
167
142
Print Profile(1)
0.2mm layer, 2 walls, 16% infill
Designer
2.9 h
1 plate
Boost
95
167
142
8
611
637
Released
Description
Print two copies of the dessicant box in one go. Print the center one from user mediaman3d https://makerworld.com/en/models/66371#profileId-69690 and then you are good to go!
This is a print profile of the wonderful model by user https://www.printables.com/@dietrich https://www.printables.com/model/299215-bambulab-ams-dryer-pod-with-indent-for-ams-fix which works better if you have tweaked your ams due to instability and made some modifications. I changed the outer layer and inner layer speed to 60mm so it has more time to cool due to the intricacy of the model. Nevertheless, easy to print with PLA.
I printed it in Bambu PLA Gray, which inside the AMS looks like it was part of the ecosystem.
Highly recommend!
Comment & Rating (142)
All
Print Profile
0.2mm layer, 2 walls, 16% infill
Flash forge burnt titanium petg, I didn’t change any settings.
The designer has replied
0
Reply
Filament color looks gorgeous!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
Hecho en pla negro
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
This part should work perfectly for it's intended use, and it printed great. It seems there is a lot of small geometry used to print this, but it came out fantastic regardless. I printed in grey ABS to hopefully match the AMS aesthetic.
*The excessive stringing is likely due to me using old and wet ABS
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
this was a nice print. I made it in white PLA. They are an exact fit.
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
Perfect for my use case
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
Wasn't expecting it to print so nicely in PETG, great use of unused space. Is very humid here atm so well worth the print, cheers mate.
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
awesome!
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
prints quite nicely with ABS Tough
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 16% infill
Holds a hearty amount of filament and fits perfect, without the hassle of the ones that go inside filament. Hard to go wrong with this one!
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld