Pin challenge good for tolerance
Copyright Claim
Pin challenge good for tolerance
Boost
10
5
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Boost
10
5
15
0
32
31
Released
Description
This pin challenge was uniquely made to test the boundaries of your 3d printer.
This quick test will show you if you can trust tall prints to finish successfully.
Comment & Rating (15)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for your feedback.
(Edited)1
Reply
What printer is that?
The designer has replied
2
Reply
That printer isn’t mine but I believe it is an AnkerMake M5C.
1
Reply
Ok, thanks
0
Reply
This is like the ultimate test of 3-D printing and cooling
The designer has replied
2
Reply
It really is.
0
Reply
This is not how the pin support challenge works...
This pin should not be printed layer-wise. You need a special g-code for this challenge. The challenge also consists of printing something on top of the pin, not just a pin.
The designer has replied
1
Reply
So your saying it needs to be thinner.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
learned some stuff about cooling from this
(Edited)1
Reply
I don't understand what you mean with that. Could you explain it to me?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for your feedback.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
1
Reply
Thanks for your feedback how did your s turn out.
(Edited)1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld