A1 Mini Purge Bucket Bin / NO SUPPORT / Remixed by 3D design shop

Remixed by

3D design shop

3D Printer>3D Printer Parts

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.24mm layer, 2 walls, 15% infill

Designer

6.5 h

1 plate

5.0(21)

0.2mm layer, 2 walls, 15% infill

6.3 h

1 plate

5.0(1)

Boost

108

244

Released

Description

However, I found there were many components to print, so I made some changes. I added a handle to easily flip it upside down into the trash. I chose to reduce its height and assemble it; now everything can be printed on one bed. Last but not least, I created my own Poop Baffle.

Everything has been thoroughly tested and works flawlessly.

I printed it with a 0.4 nozzle and 0.20 mm layer height.

Enjoy!

Documentation (2)

Assembly Guide (2)

Skærmbillede 2023-11-11 kl. 08.43.17.jpeg

Skærmbillede 2023-11-11 kl. 19.35.09.jpeg

Comment & Rating (42)

@BartmanEH

So this doesn’t use the magnetic keeper system of the original? I like the magnet keeper design of the original and have the hardware bits on hand ready to use. Also what’s the “poop baffle” for? Is it a backboard-like deflector? Maybe add an explanation of it?

The designer has replied

@3Ddesignshop

No, I removed the part with the magnets, and I've printed several without them without any issues. It stands exactly where you place it. However, if people request a remix with magnets, I can easily create that. It was mainly to simplify the printing process on a single bed 😊. It might be that I've given it the wrong name; I just saw the other one calling it a baffle 😂. Let me know if there's anything else. Thanks for the feedback!

@3Ddesignshop

@BartmanEH

Replying to @3Ddesignshop :

I have the hardware ready to go, magnets and all, but do like the idea of your single piece bin.

@speedi4got

Print Profile

0.24mm layer, 2 walls, 15% infill

Really nice work but the only negative thing I found was that the bottom screw was down too low, if you made the handle about an inch shorter than the screw placement would move up and it wouldn’t be such a PIA to get to the screw head. But a really good poop collector for the mini. I used the screws that held down my AMS unit from my P1S.

The designer has replied

@3Ddesignshop

First, I want to say thank you for reaching out to me. I will look into that right away and fix it. But have you seen that I have made a new version where the handle sits on the print in one piece? https://makerworld.com/en/models/71879#profileId-76021

(Edited)

@speedi4got

Replying to @3Ddesignshop :

no I didn’t, I will check that out I’m still using this print no problem, just a bear to get the screw in on the bottom of the handle. But it has been catching all my poop from the A1👍👍

@Intrepid3D

Print Profile

0.24mm layer, 2 walls, 15% infill

Exactly what I needed, thank you!

The designer has replied

@3Ddesignshop

It is me who says thank you for the support!

@Flyrockets

Printed with no issues I used the magnet version to avoid it being bumped around. I did have to use heat set inserts for the screws as M3 just fell through holes in handles.