Gravitrax Heightstones with tunnels
Copyright Claim
Gravitrax Heightstones with tunnels
Boost
48
120
66
Print Profile(3)
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
3x 10HSv2 0.28mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
A1Mini Gravitrax Heightstone 10
3.8 h
1 plate
Boost
48
120
66
1
269
462
Released
Description
A height block compatible with Gravitrax from Ravensburger. The bricks corresponds to 5 or 10 original dark grey height bricks and has tunnels through which the long tracks can be guided. Perfectly suitable for Gravitrax platforms.
*** UPDATE ***
I heard you guys. Now with an optimized connector that is a little less tight and shouldn't break off as easily.
Ein Höhenstein kompatibel zu Gravitrax von Ravensburger. Der Stein entspricht 5 bzw. 10 orginal dunkelgrauen Höhensteinen und hat tunnels durch die man die langen Schienen führen kann. Perfekt geeignet für Gravitrax Platformen.
*** UPDATE ***
Ich habe euch gehört Leute. Jetzt mit einem optimierten Verbinder der etwas weniger fest sitzt und nicht mehr so leicht abbrechen sollte.
Comment & Rating (66)
All
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
cool
1
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
works fine
0
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
passt perfekt.
0
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
Fine. I also tried to print upper contact layer of support with PETG (rest is from PLA) and it is great - separation after print is super easy
0
Reply
Printed out new design, fits nicely. Bambu Basic PLA green.
Thank you! :-)
0
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
0
Reply
I absolutely don‘t recommend. The connectors at the bottom brake away very fast. Would be better if there is a seperate connector.
The designer has replied
1
Reply
Thank you for your feedback. I'm sorry to hear that, but you might want to give the updated height stone with the optimized connector a second chance.
0
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
v2 is just perfect! many thanks for fixing v1 :)
(Edited)The designer has replied
1
Reply
Thank you for your feedback. I'm sorry to hear that, but you might want to give the updated height stone with the optimized connector a second chance.
0
Reply
Print Profile
3x 5HSv2 0.28mm layer, 2 walls, 15% infill
Fits perfectly to the plate
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld