CHRISTMAS SECRET ORNAMENT CONTAINER by Tactical Kaoz

Tactical Kaoz

Household>Decor

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.2 h

2 plates

4.3(6)

Fuzzy Ornament

Designer

2 h

1 plate

5.0(2)

Fuzzy ornament, all on same build plate

2.2 h

1 plate

4.6(5)

Boost

108

172

Released

Description

🎄 Unveil the magic of the holiday season with our exclusive 3D-printable ornament-container! 💜 Perfect for your family, this unique, ornament 🟣 ingeniously opens up to hide your festive treats or precious gifts 🎁. Crafted with love and a touch of holiday cheer🤗 Get yours and add a personal twist to your tree 🎅

Become a member for access to all of my designs 😁 Continue enjoying this perk for as long as you are subscribed, plus the commercial rights to start selling your creations of my designs immediately: https://linktr.ee/tacticalkaoz

The Gold Crown needs to be glued to the top part of the Ornament.

If you want a Fuzzy Ornament you will need to print out the Fuzzy Ornament Print Profile.

Comment & Rating (19)

@Print4Gods

Print Profile

Fuzzy ornament, all on same build plate

I love it thx

@mori_vinci_est

Print Profile

Fuzzy ornament, all on same build plate

This years christmas tree has some special ornaments :)

@Jeroen85

should I glue the pins in one of the halves?

The designer has replied

@TacticalKaoz

yes you have to glue the puns on wither half, I personally glue them on the bottom half.

@blake.adams.itp

Print Profile

Fuzzy Ornament

It's a very cute ornament. I printed the fuzzy one on my p1p. My only suggestion is to add the 4 connector pieces to that model. I has having a mess of a time because I thought the little supports were supposed to be the connectors at first. Finally came back to look and found my error but I think it could save time for others. As far as design goes, Great Work!

The designer has replied

@TacticalKaoz

hi there the reason they are separated is because the layer lines will cause the connector to break if printed vertical.

(Edited)

@J.lifer

I found out that superglue doesn't work on silk filaments. E6000 did. VERY VERY delicate pins to hold together. And silk won't work well for the hanger. top loop breaks easily. I printed a couple, but that will be it.

The designer has replied

@TacticalKaoz

Hi there I personally use weld on 16 it's an acrylic based glue that works insanely good with 3d prints. If you have more prints that need to be glued, I recommend weld on 16. I've never had anything break at the glue seam.