Desk Organizer USB MicroSD SD
Desk Organizer USB MicroSD SD
Boost
41
50
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
41
50
8
0
113
60
Released
Description
A quick little project for my wife's desk. She didn't need much, apart from a few USB, SD card and MicroSD holders. It shouldn't be big either, so that it saves space on the desk.
It is printed with PLA-CF
Have fun printing and if you like it, just like it and download it :-)
---------
Ein kleines schnelles Projekt für den Schreibtisch meiner Frau. Sie brauchte nicht viel, ausser das ein paar USB-, SDCard- und MicroSD-Halter dabei sein sollten. Groß sollte es auch nicht sein, damit es platzsparend auf dem Schreibtisch ist.
Gedruckt ist es mit PLA-CF
Viel Spaß beim Drucken und sollte es gefallen, einfach liken und downloaden :-)
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
no problem during printing.
very good desk accessory.
The designer has replied
0
Reply
THX
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I wasn’t paying attention and it’s way smaller than I thought but it’s super cute and it can be scaled up.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld