Cat Toy Ball
Copyright Claim
Cat Toy Ball
Boost
4
17
5
Print Profile(1)
0.12mm layer, 3 walls, 0% infill
Designer
1.6 h
1 plate
Boost
4
17
5
0
59
31
Released
Description
A simple ball with rings. Stop the print halfway and add something inside like a bell.
Print with extra walls but zero infill.
Comment & Rating (5)
All
Print Profile
0.12mm layer, 3 walls, 0% infill
It was pretty good, but I wish it rolled better
0
Reply
make a few tiny holes and put catnip inside while printing...
0
Reply
Print Profile
0.12mm layer, 3 walls, 0% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 0% infill
Strength Issue:First, let me say, I scaled this model up, so my pet did not choke on it. Used PLA, lots of stringing and wall adhesion issues, leaving some holes. The last level of the print, just pushed in and did not adhere.
0
Reply
Print Profile
0.12mm layer, 3 walls, 0% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld