Medieval Elegance Dice Tower by FrikZone3D

FrikZone3D

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.16mm layer, 2 walls, 25% infill

Designer

22.2 h

1 plate

3.3(3)

0.2mm layer, 3 walls, 15% infill

Designer

20.9 h

2 plates

2.0(2)

Boost

132

247

Released

Description

Immerse yourself in the grandeur of medieval times with our 'Medieval Elegance Dice Tower'. Designed for tabletop gaming enthusiasts, this dice tower combines functionality with the aesthetic of the bygone era. Intricately detailed, it features gothic arches, detailed stone textures, and ornate embellishments that evoke the splendor of medieval architecture. Perfect for adding a touch of elegance to your gaming sessions, this model is a must-have for anyone who appreciates the fusion of history and gaming. Print it in your preferred material to bring a piece of medieval craftsmanship to your tabletop.

Comment & Rating (21)

@MarekM

One model doesnt have complete stairs, second has a gap in the tower... both has a stairs not touching the thin walls what causes stringing while printing, could you share the sources for your model or fix it? Please remove torches inside the tower, they are useless just causing another troubles during the printing. I like this model, but ther are a lot of issues with it just because of these few things.

@HPFreeze

In the 3 wall version it looks like there are internal parts of the tower missing.

@finalequinox

Print Profile

0.16mm layer, 2 walls, 25% infill

overall, good print, not set up for clean, no support prints.

Support Issue:gap dead center of print runs through entire midsection

Other Issues:stringing all throughout the center staircase of the print and internals.

@sevenlilbears2

there are two stairs missing, did anyone figure out how to fix them? i will even glue them in at this point.

@MarekM

I did all the repairs needed for this dicetower, added some barriers to keep dice within the "courtyard", but unfortunatelly the copyright do not allow to share the remix, so I attaching the pictures of my rebuild only. Print time reduced to 16h with 0,2mm layer.

(Edited)

@smackiewiczjr

print fails about half way in, for some reason it just doesn’t print three steps near the middle and tries starting them again to no avail. absolute shame, loved the look of the tower.

(Edited)

@smackiewiczjr

Print Profile

0.2mm layer, 3 walls, 15% infill

Missing Model Parts:model looks nice but there’s a whole section of stairs missing that causes the whole print to fail mid way

@sevenlilbears2

did you figure out how to fix the stairs?

@smackiewiczjr

Replying to @sevenlilbears2 :

no, the only way to fix it would be to go in and add the stairs manually from what I can see. someone else was able to modify it tho but can’t share the files due to copyright