Huge Eiffel Tower cut in parts
Copyright Claim
Huge Eiffel Tower cut in parts
Boost
29
50
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
1 plate
Boost
29
50
3
1
163
11
Released
Description
Use the parts in the raw folder and place them on buildplate one by one.
Trying to load up all parts on plates in 1 project will take way to much time to slice!
Huge Eiffeltower multi part print
Tree support required.
Do note this takes a ton of filament, a lot of it going to waste for supports :)
Comment & Rating (3)
All
Couls it be that one of the foots is missing?
The designer has replied
0
Reply
Hi sorry for the late reply.
I'm not receiving notification for comments i think..
I just looked again and no, there is no foot missing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld