Reusable Spool - Optimized
Copyright Claim
Reusable Spool - Optimized
Boost
137
256
108
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
2 plates
Boost
137
256
108
14
793
1.3 k
Released
Description
Remix of the Bambu Lab printable spool. Reduced the material used for the side walls to a minimum while keeping overall strength and rigidity resulting in ~20-25% less print time and material usage. With the open design you can see how much material is left on the spool. Also added some holes on the inner cylinder so you can fix the filament for spooling.
Comment & Rating (108)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This has become my go to spool to use when either purchasing Bambu refills and respooling third party filament. I've printed several and they all work perfectly.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good print!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice spool adapters
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
NFC chip without care.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect 👌
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this was perfect for all the new fillament I got that I wasn’t expecting to not have a spool holder 😅😅. been using it for all my fillament now!
(Edited)
0
Reply
Boosted
Perfect print, will recommend!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0.6 nozzle, 0.3 Layer
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect print and fast. Printed 4 of them. Use them all the time in my AMS with all kinds of filament. Never had a problem.
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld