3rd remix from Versus3D great design.

https://thingiverse.com/thing:3757187

This is a design for use with magnetic disks that will hold you delta rods in place you can get them from ebay or aliexpress I got the 10mm set with balls.

THIS DESIGN IS UNTESTED I will have to build my own delta rods to try this out.

Disk dimensions are 3.55mm Thick and 11.8 Wide for use with balls that are 10mm

I had to add 2mm more plastic on the outside to make sure the magnetic holders are captured.

I never liked small plastic threads and even though the attachments for the mag balls are working great from Hayden I wanted to have everything in one assembly and the weight savings is significant going from aluminum to plastic with no degradation in quality for me.

I designed this effector plate with slots for 3 M2 nuts blower fan attachment and 2 M3 nuts for the metal plate used to attach to homing sensor.

Made a few modifications to the design to exit the hot end air more efficiently and went through the whole design fixing gaps etc and making everything symmetrical.

I used MatterHackers Carbon Fiber PETG and did a color change or pause right at the point where the screws are being covered in plastic embedding the nuts into the design.

Everything is perfectly symmetrical where the center of the E3DV6 attaches to the effector with the stock spacing of mag balls at 76mm. Just like it was intended originally with Haydens adapters.

Please note I use 4020 blower fans so basically the effector has 5 holes 3 for the fan and 2 for the leveling plate.

If your using stock fan assembly this wont work since holes were removed.

Good tip is when inserting the nuts at the pause use the screw to push it in makes it easier once inserted then screw it out.

Use Bakaks 4020 fan version its the best ! https://www.thingiverse.com/thing:3878652

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament:Prusament PC Grey

Notes: