Ivar and Skadis cable guide
Boost
4
20
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Boost
4
20
2
0
10
5
Released
Description
I had to route a cable to my filament drier in my Ivar rack unit, across a Skadis peg board. With no cable guides to hand, I decided to quickly design and print a few :)
I printed them in PETG for additional sturdiness, default settings at 0.2mm layer height worked fine.
STLs and .blend file attached if you want to play with them.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed the skadis version to keep my power cables properly out of the way. worked like a charm. no changes to the design, printed in PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld